Shijiazhuang Mets Machinery Co., Ltd
map English/ Chinese [change]  Contact Us
  Search:
 
Parts & Service
Wet parts-metal
Wet parts-rubber
PTFE bolts
Craft introduction
mets163@163.com
contact us
Parts & Service

 Advanced hydraulic model, the wet end parts has a lower wear rate.
In designing we adopt CFD(computational fluid dynamics) technology,take a calculation for pump internal passage area and external specs, simulate  the movement of the slurry inside pump stomach; adjust vane angles and thickness reasonable to got a wider wet passage, cut down the slurry  speed, then reduce the slurry strike to the wet end parts, finally low down the wear rate of wet end parts, upgrade the pump hydraulic efficiency

 

Super Anti-wear wet end parts material ensure a long life span and reliability to transfer high wearable slurry.

*Excellent NR is proved to be the prior material for wet end parts
       -Under nowadays technology  limit, the rubber wet end parts can be adopted when D50 is lower than 10mm
       -Based on survey , in the same working condition, the life span of Rubber wet end parts is over 1.5 times than high chrome alloy cast parts(KmTBCr26)
       -The NPSHr of pump has very little influence on wet end parts, which increase the life span of rubber wet end parts.
       -Rubber has a better specs than metal material under corrosive and alkaline application
.

To be the leader in areas of mining supplies and service, we welcome intelligent people in the area come us to talk about cooperate opportunities. ...
Shijiazhuang Mets Machinery Co., Ltd. Shijiazhuang Hi-tech Industry Development Zone Tel:0086-311-68058177 Fax:0086-311-68058178